STAGEMAKER CHAIN HOIST SR5 500KG D8+

Double Brake chain motor

STAGEMAKER CHAIN HOIST SR5 500KG D8+

Industrial suspension = Body Up Industrial suspension is where the hoist is mounted with load chain down and hoist body up. The hook block attaches to the load and moves up and down. The hoist body is stationary.

Climbing hoist = Body Down Climbing hoist is where the hoist is mounted with load chain up and hoist body down. The hoist body attaches to the load and moves up and down with the load. Hoists in the inverted position are easier to install and setup because all the cabling is at the same level, and the hoist is at truss level.

Mechanics

  • Single fall up to 500 kg

  • D8 as standard, BGV-D8+ ready

  • New “Perfect Push”, patented concept, 5 pocket load wheel, fitted with 5 intermediate teeth. This innovation provides improved chain guiding and chain flow, to help reduce the risk of chain jamming.

  • Mechanical overload device (clutch)

  • Disc brake(s) are located after the motor and the clutch, on a separate load path. It's directly linked to the load and will hold the load even in case of motor or clutch failure.

  • Double brake

  • Two or three step helical gear

  • Sprocket on output shaft in cantilever position

  • Operation temperature -20°C to +40°C with rated load and speed

  • Hoist body has epoxy powder 70µm thickness paint, C2 according to EN12944-2 and EN12944-5

  • DIN type upper and lower hook

  • Blued black load chain

  • Rubber buffers on the hoist body

  • Handles

  • Maximum relative humidity 90%

  • Maximum altitude 1000 m

  • CHAINFLUX Design provides a horizontal flow of the chain as it comes off of the load wheel.This design, along with the high strength aluminum construction, allows for a more fluid flow of the chain into the chain bagand helps reduce the risk of chain jamming.Drain in housing to avoid water collection in load wheel compartment.